Why Can't Lippert Solid Stance RV Step Support Kit be Used on Quad Steps

Question

Question:

why could i not mount these on the quad steps?

asked by: Tim J

0

Expert Reply:

The issue with the Lippert Solid Stance RV Step Support Kit # LC96BJ being used on quad steps is there just isn't clearance underneath them for how much space the # LC96BJ would take up. This adds about 1-1/2 inches of depth to the steps.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

Hi Heidi, I did some searching and the smallest kit I could find is the Valterra StayPut Curved Leveler and Chock for Tandem Axles part #VAL48MB. The wheel chocks are 7" long x 5 3/4" wide x 5" tall and can give your trailer up to a 4…

view full answer...

Answer 6

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 7

Hello again Monty; I would get the black SumoSprings Custom Helper Springs #SS66PV. These have a capacity of 1,800 lbs so it gives you a bit over the blue without overdoing it. SumoSprings are a great choice if you don't want to go with the air…

view full answer...

Answer 8

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 9

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Answer 10

The Dometic 3107541.009 you reference has actually been discontinued and does not have any replacement parts available, unfortunately. Instead, you'd need to replace your entire setup with a system that has a digital thermostat like the Furrion…

view full answer...

Answer 11

I actually have a Lippert Solid Stance RV Step Support Kit #LC96BJ on the trailer I'm currently working on so I was able to get the following dimensions for you: Overall length including the feet facing outward: 23-1/4" Bracket length:…

view full answer...

Why Can't Lippert Solid Stance RV Step Support Kit be Used on Quad Steps

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching