Choosing Correct Bearing Buddy Size for 2001 Coleman Taos Tent Camper
Updated 04/30/2013 | Published 04/24/2013
Products Featured in This Question
Question:
I have a 2001 Coleman Taos tent camper that I would like to install bearing buddies on. The diameter, as close as I can see, is just shy of 2. I do not have access to a caliper measuring device. Any idea what size I would need? Thanks
asked by: Johanna
Expert Reply:
The particular bearing buddy you reviewed, part # BB1781, fits a hub bore of 1.781 inches and an outer bearing number # LM11949.
Trailer and camper manufacturers may use different components in their products from one production run to another, so the only sure way to know what bearings are used in your Coleman Taos camper is to pull the wheel and hub and check the outer bearing number. Please refer to the photo provided.
The next best method is to measure the hub bore using a digital caliper. Many auto parts stores will loan or rent such tools.
I have included a link to our department page for bearing protectors where you can see the various sizes available. You will notice that we have three different sizes that are just under 2 inches: 1.938 inches, 1.968 inches and 1.98 inches.
Once you have either measured the hub bore with a caliper or confirmed the outer bearing number on your camper you can select the appropriate size bearing buddy and choose either a chrome-plated or stainless steel version.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.78 Inch
- 3000 lbs Axle
- Bearing Buddy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Motor for Lippert Power Gear Electric Leveling Jack System - Right
- Shop: Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated (Pair)
- Shop: Bearing Buddy Bearing Protectors - Model 1980 - Chrome Plated (Pair)
- Shop: Tire Chains
- Shop: Brake Controller
- Shop: Konig Tire Chains - Diamond Pattern - Square Link - Assisted Tensioning - 1 Pair
- Q&A: Replacement Motor for Power Gear Electric Leveling Jack Systems
- Q&A: Bearing Buddy that Fits Hub Bore Around 1.75 inch
- Q&A: How to Measure for Correct Buddy Bearing Fit
- Q&A: How to Measure for Correct Bearing Buddy Size
- Q&A: Replacement Motor for Lippert Electric Leveling Jack on a 2007 Fleetwood Bounder Motorhome
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: How To Tell What Size Bearing Buddy Is Needed for My Trailer Hubs
- Q&A: Determining Which Diameter to Measure for Bearing Buddy
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Replace an RV Roof Vent Cover
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Gooseneck to 5th Wheel Adapters
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision