Timbren Suspension Enhancement for 2002 Mitsubishi Montero Sport
Updated 04/26/2013 | Published 04/23/2013 >
Question:
in your description of the hollows springs, you describe they install easy and so on, but you do not mention weather these will replace the factory rear coil springs, leaf springs were only on the sports for a few years till about 99, so does this replace my rear coil springs or just assist the leaf spring models?because they came up under the parts list for my 2002 as optional parts accessories and they both aint going to fit over my axle, thanks ex mitsu tech these would be great to replace my coil springs, they are weak and hard to find, although not cheaper than adding airbags if i dont buy the onboard compressor, but beats inflating and deflating but thats what im going to have to add to carry weight
asked by: Carl
Helpful Expert Reply:
The Timbren Rear Suspension Enhancement system you mentioned, part # TMRMONSP, would replace your existing factory installed factory bump stops, and would work along with, but not replace your factory coil springs.
This system is indeed compatible with your Montero Sport, even though it has the coil springs instead of leaf springs.
The springs themselves offer a 3,000 lb capacity, but they WILL NOT increase the load capacity of your Montero Sport. You will still be limited to the original capacity of the vehicle suspension. The springs will provide additional support when the vehicle suspension is under load.
I have captured a diagram for you showing how the springs install.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is a 2" Gap Too Much After Installing Timbren Rear Suspension Enhancement System
- Article: How to Install a Roof Rack
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch


