Which Stud Goes Where on Circuit Breaker PK54220PL
Updated 07/13/2021 | Published 07/09/2021
Question:
Am I reading this right? This needs to be installed with the 12V power connected to the copper stud and the load to the silver?
asked by: Jeffrey D
0
Expert Reply:
Yes the copper stud of the part # PK54220PL goes to the battery side and the silver side runs to the accessory you are powering.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Circuit Breaker - 20 Amp - Perpendicular Mount Bracket - Cycling Auto Reset - Plastic - Type I
- Accessories and Parts
- Wiring
- Circuit Breaker
- 20 Amp
- Pollak
more information >
Continue Researching
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Best Replacement Microwave for Advent Model MW912B in a 2014 Coachman Freedom Express
- Q&A: Is The Light Bulb For The Greystone Built-In RV Microwave # 324-000105 Replaceable
- Q&A: Choosing Between Anderson Camper Levelers AM3620 and AM3604
- Q&A: Replacement For A Top Down Mount Coleman RV Air Conditioner
- Q&A: Looking for RV AC Unit that is Compatible with Top Down Setup without Air Distribution Box
- Q&A: Comparing the Curt Spectrum Brake Controller to Redarc Tow-Pro Elite
- Q&A: What Circuit Breakers Are Required for Electric Trailer Brake Controller Installation
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Performance Chips and Modules
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Replace or Install an RV Roof Vent