Installing the Wheel Masters WM8029180 on a Ford E450 Winnebago Aspect
Updated 06/22/2021 | Published 06/20/2021
Products Featured in This Question
Question:
I installed the stainless flexible tire valve extenders on my dually rear wheels but the hose is a little snug for the outside wheels. Can I install an additional 90 degree extension in series with the flexible hose that has a 90 on the end to change the angle and add the short distance to feel comfortable the hose isnt bent too much?
asked by: Ken O
Expert Reply:
If it is a little too tight, there should be no issue installing the # WM802990 to get you more room. As these will be double stacked, for the lack of a better term, I do suggest using sealing tape or Loctite when connecting the # WM8029180 to the # WM802990.
Product Page this Question was Asked From
Wheel Masters Tire Pressure Valve Extenders - 180-Degree Bend - Aluminum Rear Wheels - Qty 2
- Accessories and Parts
- Tire Repair Tools
- Valve Extenders
- Angled Extender
- Silver
- Wheel Masters
more information >
Continue Researching
- Q&A: Is The Camco Extension Chord UL Listed Or ETL Listed?
- Q&A: Correct Floor Flange Seal for Dometic 300 Series Toilet
- Q&A: Is the Steel Dual Wheel with Offset AM95NR Capable of Being Used on the Front and Rear of an RV?
- Q&A: Valve Stem Extenders for 2020 GMC Sierra 3500HD Dually
- Q&A: What TorkLift Tie Downs do I Need for My 2022 F-350, and What are the Weights?
- Q&A: Is There a Difference Between Ultra Fab Scissor Jacks and Lippert Scissor Stabilizer Jacks
- Article: Trailer Wiring Diagrams
- Q&A: Lippert Solera Power Awnings 672050 Replacement Drive Head
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Determining Trailer Tongue Weight