Can 3 Position Bilge Pump Switch # SE34FR be Used in Place of Two Switches
Updated 06/15/2021 | Published 06/11/2021
Question:
I currently have 2 switch locations, one at the console and one in the bow location. Both control the same pump. Im up grading to an automatic pump. Currently have two wires will have three with the new pump. Do I have to replace both switches or must one be eliminated all together.
asked by: Dick
0
Expert Reply:
You'd be able to use both switch locations with your current automatic bilge pump using the part # SE34FR. One of these can install in both of your locations and would work fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Seaflo Switch Panel for Bilge Pumps - Manual, Auto, Off - 12V and 24V
- Accessories and Parts
- Bilge Pumps
- Switch Panel
- Seaflo
more information >
Continue Researching
- Q&A: Air Bag Kit for Truck with Lift and Rails 2002 Ford F-250
- Q&A: Is the Trailer Hitch for a 2008 Land Rover LR2 Easy to Install
- Article: Rooftop Cargo Carriers
- Q&A: Comparing Draw-Tite and Curt 2 inch Trailer Hitches for a 2019 Honda CR-V
- Q&A: Comparing Draw-Tite, Curt, EcoHitch, and etrailer Trailer Hitches W/ 2" Receiver For 2021 Honda CR-V
- Q&A: Solution for an Advent Air Conditioner Replacing A Coleman AC With A Compressor That Won't Run
- Q&A: Replacement Taillight for a Palomino Bronco 1251