Can Trailer Landing Gear Box be Removed from Trailer with Jacks on Ground
Updated 06/15/2021 | Published 06/11/2021
Question:
Does the trailer need to be off the ground to remove landing gear gearbox? Also what gear and slip for the cross member is needed?
asked by: Matt M
0
Expert Reply:
If you were to remove the landing gear box from the set like with part # RVLG-RDBOX the jack legs would not free-spin and lower themselves so you could remove the box with the jacks holding the weight of the trailer or not.
We do not carry the cross shafts for this jack though.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Gearbox for etrailer and Ram 5th Wheel Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gearbox
- etrailer
more information >
Continue Researching
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Replacement Follow Landing Gear Leg for 1998 Fleetwood Savanna 5th Wheel
- Q&A: Replacement for Gear Box on Venture Landing Gear VMC940RB
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor
- Q&A: Replacement RV Landing Gear Motor for Atwood 75721
- Q&A: Recommended Replacement Landing Gear Set for a 2004 Keystone Cougar 5th Wheel Trailer
- Q&A: Replacement Landing Gear Motor for a ADTH E226168
- Article: What Do I Need To Tow A Trailer?
- Article: Brake Controller Installation: Starting from Scratch
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Best RV Roof Vents
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Converting Your RV Water Heater to Tankless