Wire Pigtail for Optronics 4 Inch Round LED Trailer Reverse Light
Updated 04/03/2013 | Published 03/29/2013
Products Featured in This Question
Question:
The ad description says this light uses the industry standardinch 2 prong pigtail. When I look at the picture it shows 3 prong. which one is it? Thank you
asked by: Bob D
0
Expert Reply:
Although the rear of the lamp features three pins, only two of them are active which is why the 2-prong pigtail is called for (see photo).
My guess is rather than design a separate back for lights that only need the 2 pin pigtail, Optronics finds it more cost effective to use a single back for all their 4 inch round lights.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
LED Backup Light for Trucks or Trailers - Submersible - 36 Diodes - Round - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Q&A: Will Truck Clearance And Cab Marker Light CB22AB Replace PM-120 Cab Light?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Cross Reference a Replacement for a TCM 21334 TB Grease Seal
- Q&A: Trailer Hub Replacement for 2021 Grand Design Reflection 5th Wheel with 5,200 lb Axle
- Q&A: Replacement Grease Seal for Seal with ID of 2.125 and OD of 3.371
- Q&A: Can I Replace 8-14.5 Tires with a Non-Metric Sized Tire
- Q&A: Is 14 Gauge Wire Too Small for Electric Trailer Brakes
- Q&A: Seal Size Recommendation for Dexter Axle # 8327816