Does the Plastic Molding Piece Have to Be Removed to Install the Jerry Can Holder?
Published 05/18/2021
Question:
Hi, i have a 2006 jeep x model, which i am told is the same as a tj. I am interested in the mr69mr jerry can holder, however my jeep has a plastic trim piece along lower body where mount would be, does that have to be removed for installation?
asked by: Mike H
Expert Reply:
I went ahead and confirmed with MORryde that the plastic trim piece shown in your provided photo is the standard trim molding on your 2006 Jeep X Model. With the Fender Mounted Jerry Can Holder for Jeep Wrangler TJ and YJ # MR69MR, you won't have a problem with installing the Jerry Can Holder with the plastic rim piece left on your vehicle.
(click to enlarge)
Product Page this Question was Asked From
MORryde Jerry Can Mount for Jeep Wrangler TJ and YJ - Driver or Passenger Side
- Jeep Storage
- Cargo Mounts
- Jerry Can Holder
- 18 Inch Tall
- Steel
- TJ
- YJ
- 14-1/2 Inch Wide
- 23 Inch Long
- Black
- MORryde
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What Parts are Needed to Use the Go Power SAE Plug On the Side of My RV?
- Q&A: Will MORryde Jerry Can Mount Also Fit 2" Trailer Hitch Receiver
- Q&A: Can MORryde Jerry Can Mount be Mounted to OEM Hitch Receiver on a 2021 Jeep Grand Cherokee
- Q&A: Roof Rack Recommendation for a 2023 Coleman Rubicon 1400BH Camper
- Q&A: Could Fender Mounted Jerry Can Holder for Jeep Wrangler MR69MR Attach to Hitch Directly
- Q&A: Can The Fender Mounted Jerry Can Holder Be Used On A 2" Receiver?
- Q&A: Is There Back to Hitch Opening of Swagman Swivel Hitch Extender
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hitch Mounted Cargo Carrier Information