Replacement Fan Blade for Ventline C1059H Range Hood
Updated 05/19/2021 | Published 05/17/2021
Products Featured in This Question
Question:
I have a 1976 M2100 Shasta travel Trailer. need to replace the fan blade on the hood vent. vent model # ventline C1059H . it is a 4 blade 7.25inch wide. the motor turns clock wise and has a d shaft, the right side of the blade is lower than the left side when looking down on the blade. thanks
asked by: Richard V
Expert Reply:
I may have a solution for you, but I don't show any parts that cross-reference to the Ventline C1059H, so it might be that there aren't any confirmed parts that are are a fit for it.
With that said, it sounds like the Replacement Fan Blade for Ventline RV Range Hoods - 7" Diameter # BVD0216-00 would be the correct size and will fit on the D-shaft on the motor. It's a 3-blade fan instead of 4 but it is a counterclockwise blade like the one you're replacing. I've seen this used on some other older/vintage trailer vent hoods with success.
Product Page this Question was Asked From
Replacement Fan Blade for Ventline RV Range Hood - 5-5/8" Diameter
- Accessories and Parts
- RV Range Hoods
- RV Vents and Fans
- Range Hood
- Fan Blade
- Ventline
more information >
Continue Researching
- Q&A: Replacement Fan Motor, Blade, Filter and Lens Cover for Ventline DPI-1 Range Hood
- Q&A: Replacement Parts Available for a Ventline PR-4 Range Vent Hood
- Q&A: Ventline V2244-100 Vent Fan Replacement Motor
- Q&A: Can Ventline Model V2262-50 be Upgraded to 100 CFM Motor
- Q&A: Replacement Motor, Fan, and Entire Set Up for a Ventline V2045
- Q&A: Replacement Motor & Fan Blade for Ventline Single Speed Range Hood PI-1
- Q&A: Replacement Motor and Fan Blade for Ventline PR-8 100-CFM Range Hood
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)