Hitch Tube and Ball Mount Solution for Front End Loader to Move Trailer
Updated 05/14/2021 | Published 05/12/2021
Question:
Want to weld a vertical receiver hitch on top rail of my hay fork mount on the front end loader of my tractor. Then need a ball that will in and pin to the receiver. Will just be used to move empty trailers around making it easier to park them in tight spaces. Would like a 2inch and a 2 5/16inch ball so I can move regular and gooseneck trailers.
asked by: Butch L
Expert Reply:
For a hitch opening to weld to your tractor the Combo Bar 6" part # E-9 would be a great solution for that. Then for a ball mount that has all three main sizes and even a clevis hook if ever needed the part # RP47FR would be a great solution that would cover everything.
Product Page this Question was Asked From
Combo Bar 6" with 2" Trailer Hitch Receiver - Unpainted
- Hitch Fabrication Parts
- Receiver Tube
- 6 Inch Long
- Raw Finish
- Fits 2 Inch Hitch
- CURT
more information >
Continue Researching
- Shop: etrailer 2" Clamp-On Bucket Hitch Receiver for Tractor or Skid Steer Bucket
- Q&A: Will EcoHitch Hidden Front Mount Trailer Hitch Fit 2026 Chevy Suburban
- Q&A: Replacement for a Tie Down 70lc Brake Actuator
- Q&A: Replacement Trailer Tail Light for a DOT SAE A216S2T2L 18
- Q&A: Is There a Trailer Wiring Harness for a 2017 Mercedes Sprinter 2500 That Has Both 4 and 7-Ways
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Hitch Receiver Sizes
- Q&A: Will Fulton Tandem Trailer Fender # F008583 Fit Shoreland'r Tandem Axle Trailer
- Q&A: Replacement Tail Light Lens for SAE 2AS2T216
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Brake Controller Install on 1997 Chevrolet Pickup
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Rooftop Cargo Carriers