Can Ark Drop Down Stabilizers be Used on Trailer With Corner Jacks

Question

Question:

have 30 foot travel trailer with 4 corner jacks. trailer bounces when walking inside because of tires, can this stabilizer be mounted by tires to stop the bounce

asked by: Larry O

0

Expert Reply:

Yes, your trailer with corner jacks can still absolutely use the Ark stabilizers:

- Ark Drop Down Corner RV Stabilizer Jack Kit - 24" Long Corner Steadies # ARK34FR

These will weld to the bottom of your trailer's frame, you just need to make sure you have enough room that they won't interfere with the function of your jacks and they will do a very nice job of steadying your trailer when walking inside.

expert reply by: Kyle S

0

Answer 1

We don't offer a combination leveler/stabilizer jack, but if you're wanting something in a stabilizer jack that is very sturdy, you can't go wrong with the ARK Drop Down Corner stabilizer jacks. They're available in a powder coat or a…

view full answer...

Answer 2

The Curt 45951 Rebellion Shock absorbing ball mount which we offer as part #C83WR would certainly reduce much of the shock and vibration that's experienced when towing a trailer which would absolutely make towing a more pleasant experience. Much…

view full answer...

Answer 3

You certainly can install two pairs of the Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR on your trailer. In that case we recommend adding one jack to each corner of the trailer frame. Keep in mind that these are designed to stabilize, not lift…

view full answer...

Answer 4

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 5

Good question, and we have asked the manufacturer, Ark, this very same question, and they have said there is not any weight rating for the Ark Drop Down Corner RV Stabilizer Jacks - 33" Long Corner Steadies #ARK77FR. They say the reason they…

view full answer...

Answer 6

I am not totally sure which jack you are referencing but most jacks are designed to be lubricated with white lithium grease like part #L11354.

view full answer...

Answer 7

The difference between the SolidStep Manual Fold-Down Steps #LC791573 and #LC791572 is that #LC791572 is narrower and will fit into a doorway width range of 25- 28-7/8", while #LC791573 will fit doorway widths ranging from 29" - 36".…

view full answer...

Answer 8

I wish that I could alleviate your concerns. But the Lippert SolidStep RV Steps #LC791573 does require a gap of 1/4"-3/8" for proper closure. This is not typically an issue on a 2016 or newer travel trailer. But, with you already measuring…

view full answer...

Answer 9

The Ark stabilizers won't affect your ground clearance, but to determine the right ones that really depends on how high up your frame is off the ground. Overall, the Ark RV Stabilizer Jacks #ARK34FR are 16.6" collapsed and 23.6"…

view full answer...

Answer 10

The ARK #ARK94FR stabilizer jacks could work for you, but you'll likely find they're too tall. The jacks measure 30 inches tall when fully extended or 19-1/2 inches tall when fully retracted. The existing 400914-03 jacks on your Airstream…

view full answer...

Answer 11

It looks like all of the 10x2-1/4 inch Dexter EZ lube hubs use a 10-19 grease seal, #RG06-050 for a pair of them. The K71-303-00 is the service kit number. The 2 seals are 010-019 or to shorten in, 10-19 seals.

view full answer...

Answer 12

The Ark Drop Down Corner RV Stabilizer Jack Kit #ARK34FR will work great on your Black Series HQ15 Camper. You will install these by welding them to the bottom of the frame near the rear of your camper.

view full answer...

Can Ark Drop Down Stabilizers be Used on Trailer With Corner Jacks

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching