Switch for Solera Awning to Allow it to Power In and Out
Updated 05/06/2021 | Published 05/05/2021
Products Featured in This Question
Question:
I Have a Solara 18 Volt power awning. I want to install a inside switch to move the awning. I was thanking or the LC285500 switch. Can this be done and still charge the battery. If not do you have any suggestions?
asked by: Don J
1
Helpful Expert Reply:
The Solera switch part # LC285500 that you referenced was designed to fit all Solera power awnings so it would work well to give you an inside switch to extend and retract. This would not affect the batteries ability to charge either.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Replacement Switch for Solera 18V Power RV Awning
- Accessories and Parts
- RV Awning
- Switches
- Solera Replacement
- Lippert
more information >
Continue Researching
- Q&A: Can The 69" Solera Wiring Harness LC56ED Be Used In Place Of A 63" Wiring Harness?
- Q&A: Troubleshooting Solera Smart Arm Power Issues
- Q&A: Replacement Microwave Option for an Apollo Halftime AAC34BIB
- Q&A: How to Wire Replacement Switch for Solera 18V Power RV Awning
- Q&A: Replacement Wiring Harness for Solera SmartArm Awning for Rain Sensor
- Article: Trailer Wiring Diagrams
- Q&A: Do Solera Replacement Batteries and Awning Switch Wire to Each Other
- Q&A: Are Weld-On or Bolt-On Installations Stronger for a Trailer Jack
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size