Are There Replacement Gears for 2-1/2 Inch Wide Fulton Magnum Trailer Jack

Updated 05/05/2021 | Published 05/03/2021

Products Featured in This Question

Pro Series Square Jack with Footplate - Drop Leg - Sidewind - 28-5/8" Lift - 5,000 lbs

(134)

$86.16

Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 12" Lift - Zinc - 1.5K

(1738)

$142.82

Question:

I have a 1999 Rinker Fiesta Vee 270. The trailer has a striped tongue jack. I am not sure what kit to purchase to repair the jack. I think some parts are missing. I didnt take it apart so unsure how it goes back together. The handle is very loose and nothing holds the handle in the sleeve. Under the cover it says Fulton Magnum Series. The outermost square tube is 2 1/2inch x 21 3/4inch long. The jack is welded to the trailer and painted so I cannot find the model number anywhere.

asked by: Jarod S

Expert Reply:

I may have a solution for you, but we've previously determined that a Fulton Magnum series where the outer tube is greater than 2-1/4" wide does not have replacement gears available. The only available solution would be to replace the jack in this case. You could use a similar jack like the Pro Series Square Jack with Footplate - Drop Leg - Topwind - 28-5/8" Lift - 5,000 lbs # PS1400800383, which is a square tube jack with a drop leg that will weld to your trailer frame. This would be a good option if you have access to a certified welder.

You could also go with something with a wheel, that also bolts on, like the Fulton # FXP15L. This can bolt on to either side of your trailer frame, so you could have your old jack removed or just install this on the opposite side.

I've linked some review videos of these options for you to check out.

expert reply by: Erik B