Parts Needed To Install EcoHitch Trailer Hitch Receiver 306-X7239 On 2013 Ford Fusion
Updated 04/30/2021 | Published 04/29/2021 >
Question:
When installing the hitch receiver on a 2013 Ford Fusion Titanium, once the panel is removed is there a speaker that will require the Speaker Bracket? IF so what parts are all needed? Also with how low the car already is can a hitch ball mount but used upside downinch to be used as a riser?
asked by: Kim P
Expert Reply:
There is not always a speaker behind the rear bumper on the Ford Fusion, so you will need to check under the bumper to see if your particular 2013 Ford Fusion has the speaker or not.
If you do you will need the # 18136 to make a bracket to move it out of the way of the EcoHitch Trailer Hitch Receiver # 306-X7239. You will also need to source two nuts and bolts to secure the speaker to the bracket.
You can absolutely use a ball mount upside down to get the correct rise needed to tow your trailer level. To determine how much rise you will need you will need to level your trailer and measure from the ground to the bottom of the coupler of your trailer.
When we installed the # 306-X7239 on a similar 2020 Ford Fusion we found that from the ground to the top inside edge of the receiver was 10". The difference between these two measurements will be the amount of rise you need to tow your trailer level.
If you can tell me how much rise you need I would be happy to recommend the correct ball mount. I went ahead and included a link to all of our ball mounts for you to look through as well.
Lastly to complete your towing setup you will need a vehicle wiring harness # 118574.
I included installation videos for both of the products mentioned for you to take a look at.
Product Page this Question was Asked From
EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- EcoHitch
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trailer hitch
- Search Results: hitch receiver
- Shop: EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Hitch
- Q&A: Will EcoHitch Hidden Trailer Hitch Receiver Fit 2019 Ford Fusion Titanium
- Q&A: Is there a 2 Inch Hitch for a 2019 Ford Fusion?
- Q&A: Towing Capacity of a 2016 Ford Fusion SE and Trailer Hitch and Wiring Recommendations
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Replacement AC System for a 48209-0650 Coleman Mach 15 Power Saver Ducted Quiet
- Q&A: Will the 18k Coleman-Mach Everest Work w/a Multi-Zone Setup or Does it Require it's Own Thermostat?
- Q&A: Will The EcoHitch fit a 2017 Ford Fusion Titanium AWD?
- Q&A: Looking for SumoSprings/Timbrens for 2005 Winnebago Sightseer 29R on Workhorse P32 Chassis
- Article: How to Choose the Right Trailer Hitch Class
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches



