Will MORryde Horizontal Sliding TV Wall Mount Fit Jensen RV TV
Updated 04/30/2021 | Published 04/29/2021
Question:
Will this mount accept a 32inch Jensen JTV3217DC 32inch TV. If so will it then slide in and out of my RV basement door? Slide in far enough to close the door, slide out far enough to pivot on the outside of the trailer?
asked by: Scott S
Expert Reply:
Yes the MORryde Horizontal Sliding TV Wall Mount # MR82ZR does fit your Jensen JTV3217DC # JTV32DC TV as it has the standard VESA bolt pattern.
It was designed for exactly what you are looking for as well where you mount it on perpendicular wall and then slide it out and pivot so you could watch it outside of your RV so it would work well in that regard as well.
Product Page this Question was Asked From
MORryde RV TV Wall Mount - Horizontal Slide/Swivel - 35 lb Capacity - Steel
- RV TV Mount
- Wall Mount
- Extend
- Swivel
- Steel
- 180 Degrees
- 100 mm x 100 mm
- 200 mm x 200 mm
- 75 mm x 75 mm
- Manual
- 35 lbs
- MORryde
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Troubleshooting Error Code 4 of Curt RVI Series 4 Supplemental Braking System
- Q&A: Will a Fortron Model TP3SS-55 Work With a Lithium Battery
- Q&A: Correct Gen-Y Hitch Gooseneck Pin Box for 2025 Jayco Eagle 317ROLK
- Q&A: Recommended TV Mount For a Keystone Montana Storage Area
- Q&A: Is There A Goosebox That Can Replace The Reese Revolution 16K Pin Box?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Will SumoSprings Help With Sag When Towing With 2024 Ram 3500
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Measure for Trailer Hitch Drop