Slide Topper Awning For 121.5" Flange To Flange Measurement

Updated 04/22/2021 | Published 04/21/2021

Products Featured in This Question

Solera RV Slide-Out Awning - 121" Wide - Black

(1438)

$593.21

LaSalle Bristol Butyl Tape for XTRM RV roof membranes - 30' x 3/4" - Gray

(198)

$26.30

Question:

2021 Alliance Valor 36V11 On the door side the slide out is between two existing awnings. Im trying to size a slide topper that will fit and wont interfere with the existing awning support bars when they actuate. Ive attached a picture, the slide flange to flange width is 121.5. The front flange edge is 2.5inch from existing front awning support bar and the rear is 3. Is it possible to add a slide topper that wont interfere with the existing awning supports when they actuate? Thanks, jay

asked by: Jay B

Expert Reply:

For your specific measurement and clearance I recommend the Solera RV Slide-Out Awning - 10'1" Wide - 48" Projection - Black Item # LCV000182037.The arms are going to need 2.75" of clearance so you'll need to center the topper 1/4" to the left to make sure the arms will fit between your other awning arms.

I also recommend using Butyl Tape Item # 344270341410-1 to help waterproof the screw holes for your brackets.

expert reply by: Kevin C