What Size Spade Connectors Does Atwood Switch # AT91959 Use
Updated 04/21/2021 | Published 04/20/2021
Question:
What size are the prongs? Like what size connectors do I need to plug into the back? Thanks.
asked by: Marc B
0
Expert Reply:
The spade connectors on the back of the Atwood switch part # AT91959 are the standard 1/4 inch size commonly found on spade connectors.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters - Black
- Accessories and Parts
- RV Water Heater
- Switches
- Black
- Atwood
more information >
Continue Researching
- Q&A: Recommended Replacement for Atwood G6A-7 Water Heater
- Q&A: Lippert Crank Handle for Lippert Spare Tire Winch Assembly
- Q&A: Replacement Water Heater Recommendation for Atwood G6A-7P
- Q&A: Looking for Instructions for Under Bench RV AC Unit
- Q&A: Parts Needed to Go From Atwood Water Heater to Dometic
- Q&A: Replacement Switch and Wiring Diagram for Atwood G6A-8E
- Q&A: Troubleshooting A Furrion Range/Oven Knob That's Always Lit Up Red
- Article: Converting Your RV Water Heater to Tankless
- Article: What are the Common Types of Propane Fittings Used on RVs?