Do I Need to Add Resistors to the Bargman Triple LED Tail Light
Published 04/10/2021
Products Featured in This Question
Question:
I have a 2013/2014 Thor Freedom Elite on a Ford E350 chasis.
asked by: Marie
0
Expert Reply:
If your RV currently has incandescent lights and you're going to be adding the Triple LED # CE44VR to the mix then you will most likely need to add resistors like the Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2 # DI34ZR to the turn signal circuits. This will keep your blinker from hyper-flashing and allow them to function normally.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn/Backup
- Rectangle
- Non-Submersible Lights
- LED Light
- 14L x 6-7/8W Inch
- Red
- White
- Command Electronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Possible Light Replacement For Monarch 5129 On 1977 Great Divide Trailer
- Q&A: Replacement LED Light for the Command 003-30
- Q&A: Is There a Replacement for a Trimark 030-0900 Door Latch
- Q&A: How To Find Correct Replacement Taillight for Winnebago Minnie Winnie
- Article: Trailer Wiring Diagrams
- Q&A: Valve Stem Extension Recommendations for RV with Dually Wheels
- Q&A: Bearing Kit Recommendation for 84 Spindle K71-717-00
- Q&A: Do Studs of Optronics Fusion LED Trailer Light Thread Out Easily
- Article: Trailer Lighting Requirements
- Article: How to Tie Down a Kayak (Without a Roof Rack or Pool Noodles)
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Best Bike Racks for Electric Bikes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)