Can Dutton-Lainson Wiring Harness For StrongArm TW4000 DL24152 Be Installed Under Bumper Of Truck?
Updated 04/05/2021 | Published 04/01/2021
Products Featured in This Question
Question:
Possible to mount under the bumper? Dust cover available? then make the jumper?
asked by: Craig H
Expert Reply:
You can mount the Dutton-Lainson Wiring Harness for StrongArm Electric Winch Model TW4000 Manufactured after 2014 # DL24152 you were looking at underneath the bumper of your 2021 Ford F-150 to plug your Dutton-Lainson TW4000 StrongArm Electric Winch - Marine # DL25200 into without a problem.
You would need to use the quick connects # DL24086 and # 10-1-1 to go from the winch to the plug underneath your bumper, or if the # DL24152 has enough length to go directly to the winch you can cut the wire and the install the quick disconnects on both ends.
You do need to solder the # DL24086 to the wire instead of crimping it.
While there is not a dust cap made for the # DL24152, the # BDW58SV should fit just fine.
I included a few videos of the products mentioned for you to take a look at.
Product Page this Question was Asked From
Dutton-Lainson Wiring Harness for StrongArm Electric Winch Model TW4000 Manufactured after 2014
- Accessories and Parts
- Electric Winch
- Wiring
- Wiring Harness
- Dutton-Lainson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Winch Recommendation for Trailer with 4,000 lb Boat
- Q&A: Higher Capacity Replacement For Shelby 5407 Hand Winch
- Q&A: Selecting Electric Boat Trailer Winch with Manual Operation Capability
- Q&A: Troubleshooting External Sensor Error on Lippert Leveling System
- Q&A: Is Bulldog Winch Controller 20125B Water Resistant and Double Pole Reversing
- Article: How to Wire an Electric Winch
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Replacement 80 Amp Circuit Breaker for StrongArm Winch TW9000