How To Run Power Wire for Curt Harness on 2016 Honda Fit
Updated 04/02/2021 | Published 03/31/2021
Question:
Hi 2 question please 1- do I connect all the wires from the unit to the tail light or just the yellow/white 2- where do I run the power wire to the battery Thank you
asked by: Bernie M
0
Expert Reply:
The correct Curt T-Connector Vehicle Wiring Harness for a 2016 Honda Fit is part # C56383. There are three separate connectors, all of which must be used. In regards to the power wire, this will need to be run to the vehicle battery. The easiest way is to find a grommet to route the wire outside and then up to the battery.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: 2018 VW Atlas 7-Pin Round Vehicle Connector and Brake Controller for Use w/ a 6-Way Adapter
- Q&A: Length of Parking Brake Kit Cable
- Q&A: Curt Powered Converter Lead Instruction Sheet CME-PCL-INS
- Q&A: Comparing Curt 2 Inch Trailer Hitch Receiver to Draw-Tite 2 Inch Receiver for 2018 VW Atlas
- Q&A: Comparing Curt 2 Inch and Draw-Tite 2 Inch Trailer Hitches for a 2019 Volkswagen Atlas
- Q&A: Recommended Hitch for a 2024 Mazda CX-90 PHEV
- Q&A: Can the Wiring Harness for a 2018 Volkswagen Atlas be Mounted Outside the Vehicle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Hitch Receiver Sizes