Friction Sway Control Ball Mount Bracket Solution for Hitch Ball with 1-1/4 inch Shank
Updated 03/18/2021 | Published 03/15/2021
Question:
Im looking for a bracket for my trailer hitch to add a anti sway system. I have a Curtis hitch with 2 and 5/16 ball that has a 1 1/4 shank.
asked by: Mike M
0
Expert Reply:
You could use a weld on tab for the side of your current ball mount with the part # C45822 but since the shank diameter of your ball is 1-1/4 inch there isn't a bracket that can fit under your ball as for that style there's only options that fit the 1 inch diameter shank balls.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Q&A: Recommended Friction Sway Control System For Dual Friction Setup
- Q&A: Recommended RV Awning For A 2021 Winnebago Solis 59PX
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Q&A: Which Side Should Friction Sway Control Bar Be Installed On
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Q&A: How to Properly Set the Tension on the Curt Sway Control Bar # 17200
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Article: Trailer Wiring Diagrams
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Ram Trailer Tow Prep Package
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size