Can the CargoSmart Board Holder Be Adjusted Without Removing the Boards
Updated 03/01/2021 | Published 02/24/2021
Question:
So to make this fully adjustable using 2x4s it looks like you have to cut the wood short so that you can access the small tab located at the back of the bracket??
asked by: Steven G
Expert Reply:
In regards to the CargoSmart Board Holder part # 348892, you'll need to remove the board completely to adjust the brackets. The brackets need to come out away from the track in order to change positions. It's not required that you screw the boards to the bracket. If you were going to frequently adjust the brackets then I would not use screws.
I suppose it is possibly to try and cut the boards shorter to adjust the brackets without removing the boards but I really don't have much advice on this unfortunately as it's not something we've tried.
Product Page this Question was Asked From
CargoSmart Board Holder for E Track and X Track Systems
- E Track
- E Track Cargo Organizers
- Board Holder
- CargoSmart
more information >
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams
- Q&A: If e-Track Beam Sockets Were Attached to Board on Both Sides Would it Be Possible to Remove e-Track
- Q&A: Availability of Adapter for Old Bargman 35 amp Electrical Inlet for Camper
- Q&A: Compatibility of 3 Prong Twist Lock Power Outlet on Power Panel
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150
- Q&A: Troubleshooting Prodigy RF Brake Controller Installation in 2017 Mercedes-Benz GLE-Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Difference Between 30205 and L44643 Bearings
- Q&A: Folding Table Recommendation that Can Mount Onto the Side of a Travel Trailer
- Article: Camping Tips for First-Time RVers
- Article: Big Truck Big RV
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: How (and Where) to Connect an RV Propane Grill