What is Minimum Diameter Hole Needed to Install Valterra Water Inlet RF911BK
Updated 02/16/2021 | Published 02/13/2021
Question:
What is the minimum cut out hole needed for this model? Thanks.
asked by: Haston
0
Expert Reply:
The barb fitting on the backside of the Valterra Water Inlet # RF911BK starts out at 1-1/4 inch at the end and then gets a little wider towards the base at 1-3/8 inches which means that the minimum diameter hole it would fit through is 1-3/8 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra RV Gravity Fill Water Inlet - Fill Spout
- RV Water Inlets
- Gravity Fill Inlet
- Flush Mount
- Plastic
- Black
- Valterra
more information >
Continue Researching
- Shop: Valterra RV Gravity Fill Water Inlet - Fill Spout
- Video: Feature Review Valterra RV Gravity Fill Water Inlet
- Q&A: Will the Redarc Tow-Pro Link Bluetooth Brake Controller Work w/a 2026 Outback w/a Factory 7-Way?
- Q&A: Weight Distribution Recommendation for 2026 Jayco Feather 19MRK
- Q&A: Is The Weight Of A Weight Distribution Hitch Factored Into Tongue Weight Or Truck Payload?
- Q&A: Recommended 90° Sewer Adapter for a Dump Station
- Q&A: Does The Coleman-Mach Signature Mach CM42RR Include A Control Box?
- Q&A: Looking for Just Driver Side Brake Assembly of Dexter Nev-R-Adjust Set for 3,500 lb Axle
- Article: Determining Trailer Tongue Weight
- Q&A: Installation of Mounting Rail for Camco RV Grill
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Best RV Roof Vents
- Article: How Does an RV Water Pump Work?
- Article: Trailer Maintenance Schedule
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today