Replacement Head for Reese Weight Distribution System with 22210 Spring Bars
Updated 02/15/2021 | Published 02/11/2021
Question:
Hello, I have an older Reese weight distribution hitch with a broken latch pin, I would like to purchase an replacement head for my set-up. My existing hitch only has the numbers 555 and possibly followed by two 00. It looks like the number is 55500. I tow a tow behind travel trailer that has a 6900 GVWR and unloaded TW of 638. I have two sets of trunnion bars, one set has a number of 22210-G and say 750lbs. These are straight. The other set has the number 22210-H and say 800lb. These have a bend on the ends unlike the straight ones above. My ball hitch is 1 1/4 shank. Could you tell me if I can buy a replacement head is it #RP58167 and if I can buy a replacement head, will the 22210-H trunnion bars rated fro 800lb TW fit the replacement head, I would like to use my existing shank and 1 1/4 ball with this replacement head. I have pictures if they will help. Any help would be appreciated. Thank you very much!
asked by: Peter
Expert Reply:
If the spring bars have 22210 stamped onto them then you can use the Replacement Head for Reese Weight Distribution System part # RP58167 which will allow you to reuse your existing hitch ball, shank, and spring bars.
Continue Researching
- Q&A: Recommendation For Snap Up Replacement Brackets For Weight Distribution System
- Q&A: Replacement Snap-Up Brackets For a Pro Series Weight Distribution System
- Q&A: Is the 58167 Reese Replacement Head The Same as the 62167 Weight Distribution Hitch Head
- Q&A: Matching Shank With 2 Inch Receiver for Reese Titan Weight Distribution System
- Q&A: Can Curt Spring Bars Be Used With A Reese Weight Distribution Hitch Head
- Q&A: Replacement Snap Up Bracket Recommendation for Reese Weight Distribution System
- Shop: Replacement Hook Up Brackets for Curt Weight Distribution Systems
- Shop: Blue Ox SwayPro Weight Distribution w/ Sway Control for 2" Hitch - 7.5K GTW, 750 lbs TW