CE76FR Motion Light Malfunctioning
Updated 12/11/2020 | Published 12/09/2020 >
Question:
Replaced motion light and it is still turning off and back on every ten seconds with no motion in trailer.
asked by: Jon
0
Expert Reply:
It sounds as if the sensor on your LED RV Security Light part # CE76FR has failed and the light will need to be replaced. I have seen this before but it is not very common. For some reason your sensor is telling the light it sees motion when in fact as you said it does not.
expert reply by:
Randy B
0
Product Page this Question was Asked From
LED RV Security Light - Motion Detector - Surface Mount - Clear Lens - Warm White
- RV Exterior Lights
- Porch Light
- Hardwired
- Surface Mount
- LED Light
- 12V
- Black
- Command Electronics
more information >
Continue Researching
- Q&A: Will Thermostat of Furrion Variable Speed Chill Cube Work with Furnace
- Q&A: Can Furrion Chill Cube AC System Work With Furnace On Existing Thermostat?
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Q&A: Does Lippert Schwintek Slide-Out System Column Height Include the Motor Height?
- Q&A: What Tire Pressure Should Castle Rock ST225/75-15 be Ran At
- Q&A: Wiring Diagram for the Dometic Replacement Single Zone Thermostat
- Q&A: Replacement 14v4w Light Bulb for a 2008 Forest River Berkshire Motorhome
- Article: How Much Solar Power Do I Need For My RV?
- Article: Best RV Roof Vents
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Converting Your RV Water Heater to Tankless

