Replacement Remote Control Socket Assembly for Superwinch Tigershark TS9500 Electric Winch
Updated 12/04/2020 | Published 12/03/2020
Question:
have superwinch tiger shark ts9500, looking to replace cover where remote plugs into housing, cracked on both sides by screws. thank you
asked by: Scott B
0
Expert Reply:
Superwinch doesn't offer only the plate as a replacement part. You'd need to replace the whole socket, which is Superwinch 90-24573, our part number for it is part # SW94FR.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Replacement Remote Control Socket Assembly for Superwinch Winches
- Accessories and Parts
- Electric Winch
- Remote Control
- Socket
- Superwinch
more information >
Continue Researching
- Q&A: Replacement Handheld Remote For a Older 4500 Series SuperWinch
- Q&A: Recommended Way To Replace Shear Pin On Lippert Components Power Stabilizer Jack
- Q&A: Wiring Diagram for Replacement Solenoid on Superwinch
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Parts Needed to Install Replacement Leg for etrailer and Ram Hydraulic Jack Setup on Dump Trailer
- Q&A: Replacement Hubs for Karavan 2004 Double PWC Trailer
- Q&A: Why Does Light of Tekonsha Primus Brake Controller Stay On
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time