What is Retracted Height of Powerbuilt Unijack # ALL620470

Question

Question:

Greetings, What is the height of the lift jack #ALL620470 when it is fully compressed? I need to make sure that it can fit under an ATV, as the ATV only has a 10 ground clearance. Thank-you.

asked by: Richard G

0

Expert Reply:

When the Powerbuilt Unijack # ALL620470 is in it's lowest position it's overall height is 8-5/8 inches. When fully extended the height is 18-3/8 inches.

expert reply by: Jameson C

0

Answer 1

Hello Eugene, You’ll have no problem towing the Thule Outset at highway speeds #TH34FR39XB, it’s built for real-world travel. Once it’s folded up for transport, the tent is completely secure and stable, and Thule rates it for normal highway driving…

view full answer...

Answer 2

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

view full answer...

Answer 3

I went out to the warehouse to measure BoatBuckle G2 Retractable, Ratcheting Transom Tie-Downs #IMF08893. The overall width at the widest point is 4-5/8 inches. The mounting hole is right in the center so from either edge to the center of the…

view full answer...

Answer 4

The Powerbuilt Unijack #ALL620470 referenced in your question has a weight capacity of 4,000 pounds. This is likely enough for your 8,200 pound trailer, but I recommend going up a bit with the Unijack #ALL620471 that is rated for 6,000 pounds. This…

view full answer...

Answer 5

The measurement I believe you're looking for on the BoatBuckle G2 ratchet straps, part #IMF08893, is about 4-1/2 inches. I've attached a picture that shows the dimension. If this isn't the correct measurement let me know.

view full answer...

Answer 6

Hey Kevin! The Outset #TH34FR39XB actually uses your entire 2inch hitch receiver, and because it’s deployed as a tent and not towed like a normal trailer, you won’t be able to tow anything else while it’s in use. There’s no pass-through hitch or…

view full answer...

Answer 7

Hey Todd! At the lowest setting, the saddle of the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR sits at 14" and the top of the saddle arms are at 15-3/8". I took a photo of it out in our warehouse, and while I wasn't able to get…

view full answer...

Answer 8

Hey John, since your Coleman Mach 38200 is a Mach 15 the correct air filter set you'd need is the part #RA98QV.

view full answer...

Answer 9

You'll have to measure the outside dimensions of the base of your 22 inch Blackstone but the most likely to fit MORryde Generator tray would be the part #MR89RR you mentioned which has inner dimensions of 17-1/2" long x 20-3/4" wide x…

view full answer...

Answer 10

What you have is a wishbone style of 5-way that has the ground and running light circuit split for either side of the trailer. You can replace this setup with one that has a single wire by running both of the wires on the trailer side to the new…

view full answer...

Answer 11

What you have is a 5-way with a double wishbone, which means it is likely a double wire for marker lights as well as a double ground. You can replace your 5-way with another wishbone-style but it does not need to be a double wishbone with 7 wires,…

view full answer...

Answer 12

I've linked a help article that will give you the common color coding but on your trailer I wouldn't go by it. Even if they are correct you just never know so I suggest testing it. To test it cut off the 5-way connector that's on there…

view full answer...