Will Curt Class I Hitch C11427 Work For Pulling Motorcycle Trailer With 2006 Toyota Avalon
Updated 11/27/2020 | Published 11/25/2020
Products Featured in This Question
Question:
will this support a motorcycle trailor
asked by: Herb Y
0
Expert Reply:
As long as the motorcycle trailer doesn't weigh more than 2000 lbs fully loaded and have a tongue weight greater than 200 lbs, the Curt Class I hitch, part # C11427 would work just fine for a motorcycle trailer.
In order to complete your towing setup, you'll need a trailer wiring harness like # 119178KIT, a ball mount like part # C45022 and a # PC2 hitch pin and a 1-7/8 hitch ball like # A-80 or a 2 inch ball like # A-82
expert reply by:
Mike L
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: Replacement Hub and Drum Assembly With 5 on 5 Bolt Pattern for 3,500 lb Rockwell American Axle
- Article: Trailer Lighting Requirements
- Q&A: Is There Fascia Trimming Required to Install the Curt Hitch # C11427 on a 2011 Toyota Avalon
- Q&A: How to Route the Power Wire of a Powered Taillight Converter
- Q&A: Trailer Wiring Harness For A 2013 Toyota Venza
- Q&A: Trailer Hitch Recommendation for 2007 Toyota Avalon
- Q&A: Why Does Curt Trailer Hitch for 2008 Toyota Avalon have Higher Towing Capacity than Vehicle
- Article: How to Choose a Hitch-Mounted Bike Rack
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)