5K Capacity Bulldog Jack Is Jammed and Will Not Raise or Lower Trailer
Updated 11/20/2020 | Published 11/18/2020
Products Featured in This Question
Question:
I have a Bulldog Max Capacity of 5,000 lbs lift and 8,000 lbs static and will not crank down or up, what are the parts i would need for this?
asked by: Adam G
Expert Reply:
According to Bulldog, the jack has been either over extended or retracted and the main screw inside that runs the jack in and out has jammed into the nut. If using a reasonable amount of force won't successfully retract or extend the jack, then Bulldog recommends that the jack be replaced as the screw has been damaged and a replacement part isn't available.
The closest replacement to your original jack is part # PS1400800383.
Product Page this Question was Asked From
Replacement Gears for Bulldog Sidewind Trailer Jacks with 5,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Brake Controller
- Search Results: ufp
- Shop: Vehicle Tow Bar Brake System
- Video: DIY Install: etrailer Trailer Hitch Receiver on your 2023 Chevrolet Equinox
- Video: Mount: etrailer Trailer Hitch Receiver on a 2018 Chevrolet Equinox
- Shop: Gooseneck Hitch
- Shop: Camper Tie-Downs
- Video: Review of the Durabilt Double Clevis Link for 5/16" Thick Chain
- Shop: Dexter DX7.5L A-60XL Brake Actuator w Electric Lockout - Weld On - Disc - 2" Ball - Primed
- Search Results: 119177
- Search Results: 185400
- Search Results: stl~78rb
- Search Results: stl78rb
- Search Results: 56427
- Search Results: boat buckle
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: 50MM Nev-R-Lube Bearing for 8,000-lb Dexters - Qty 1
- Shop: TorkLift Tie Downs - Custom Frame Mount - Front and Rear
- Shop: 7-Leaf Slipper Spring w/ Hook End for 8,000-lb Trailer Axles - 26-5/8" Long
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Recommended TorkLift Steps for Palomino SS1240 Pop Up Camper
- Q&A: Jack Handle Replacement for Bulldog 8k Square Jack 190574
- Video: Detailed Breakdown of the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear
- Video: What to Know About the Brophy Camper Scissor Steps
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Replacement Sidewind Gear Kit for a Bulldog 190754 Jack
- Q&A: Landing Gear Replacement Recommendation for 1997 Fleetwood 5th Wheel w/ RBW Landing Gear