Search: 6 leaf slipper spring   >  

There isn't a specific distance the hangers have to be for hanger kit #AP216-H238. A good place to start is 30-1/2 inches on center but you would only really know by mocking it up on the trailer before permanently installing the hangers. To…

It sounds like you are heading in the right direction. To decide where your springs seat will be you will need to mock up your trailer as if you were installing all of the equipment on it. Once you have the suspension part mocked up you will want to…

It may be possible to change your studs from 1/2" to 9/16" so long as the studs are drive-in (as opposed to threaded); also, the length and knurl diameter needs to be the same. For example, the Kodiak Wheel Bolt - 9/16" Diameter x…

When you replace the axles on a trailer you will look at the (A) hub-face-to-hub-face and the (B) spring-center-to-spring-center measurements and choose an axle that has the same measurements that your current axle does. Since you are wanting to add…

I have a solution for you, however, the newly-updated Curt A-Series Fifth Wheel Hitches are NOT compatible with Reese Sidewinders, and they haven't been confirmed to fit other rotating pin boxes either. For this reason, I recommend to a Curt…

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

Congratulations on your new Elkhart! I'm sorry to hear you're having trouble getting your Greystone fireplace to work. There are troubleshooting steps you can take to try to get your fireplace working again. The manufacturer recommends…

The bushing that goes with the slipper spring #DX73QR is part #DX77XR. The bushing has a 5/8" diameter so it will work perfectly with the hanger kit #HAP-105-00.

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

The pin in the 1:00 position on your 7-way is fed by the auxiliary power circuit. The wire feeding that circuit runs to the engine compartment and terminates under the brake booster and master cylinder and will have a ring terminal on the end of it.…

On GM vehicles of that vintage, the 12-V pin should be hot regardless of whether the ignition is on or not. If it isn't showing voltage even with the ignition on, you're almost certainly on the right track thinking it's a blown or…

Since you are building a trailer I first want to state that using quad axles isn't ideal. It will cause tire scrub as there becomes too broad an axle base for the trailer to track as nicely. That is why most trailers will use tandem or triple…