Can Optronics Clear Tractor, Utility Light # TL10CB be Used on a 24 Volt System
Updated 12/11/2012 | Published 12/10/2012
Products Featured in This Question
Question:
I want to install this light on my Dozer that has a 24 volt system. Can you tell me the best way to do this?
asked by: Joann G
Expert Reply:
If the batteries on your tractor are connected with one grounded to the chassis and the positive going to the negative of the next battery then you can connect a 12 volt light on a 24 volt system. The power wire for the light will need to be connected to the wire that is between the 2 batteries like in the picture I have included.
We also recommend using a circuit breaker in line on the power wire leading to the light, # PK54530.
Product Page this Question was Asked From
Optronics Utility Work Light - Rubber Housing - Incandescent - Round - Clear Lens
- Work Lights
- Work Lights
- Exterior Lights
- Round
- Pedestal Mount
- Incandescent Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Q&A: Replacement Lens Recommendation for a Light Stamped SAE P2 93
- Q&A: Is There a Weld Pattern for the Sleeve-Lock A-Frame Trailer Coupler # CA-5296-B?
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Replacing Dometic Penguin I with Penguin II, What is Needed
- Q&A: How To Wire Light Bar On Trailer With Switch In Vehicle
- Q&A: Correct Replacement Hubs/Drums and Brakes for a Dexter 4,000 Lb Axle
- Article: Trailer Wiring Diagrams