How To Fix 1" Gap After Installing Timbrens On a 2000 Ford F-250
Updated 10/05/2020 | Published 10/02/2020
Products Featured in This Question
Question:
I just installed this part on 2000 F250. There a large gap between the unit and the axle. Timbren says on a heavy truck like mine there should be little to no gap. I have over an inch. Kind of defeats the whole purpose of the intall.
asked by: Monte M
Expert Reply:
The Timbren Rear Suspension Enhancement System part # TFR150SDE which is a fit for a 2000 Ford F-250 is designed to produce around 1/2" - 1-1/2" gap. It will still work to reduce sag/squat with a gap but not till the threshold of the suspension is reached. Some prefer more of a buffer than others since the ride can be rougher when engaged. Nevertheless, you can use the spacer part # A25723-90AH00 for 1" or part # TA25722-90P00 for 1/2" to close the gap.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is the Factory Transmission Cooler Good Enough for Towing
- Q&A: Will Airbags Work on a 1994 Ford F-250 with In-Bed Hitch
- Q&A: Timbren Rear Suspension Enhancement for a 1989 Ford F-250 GVW of 6600 lbs
- Q&A: Rear Suspension Enhancement System for a 2000 Ford F-250 4x4 Towing Gooseneck Trailer
- Q&A: Is There A Limit On How Many Spacers I Can Use With Timbren Rear Suspension Enhancement System?
- Q&A: Rear Helper Springs to Reduce Squat on the Back of a 1999 Ford F-250 Towing 12K Dump Trailer
- Q&A: How Many Lift Spacers are Needed for Timbren Springs on a Lifted 2013 Chevy Silverado 1500