Boat Trailer Spare Tire for 5.70x8 With 4 on 4 Inch Bolt Pattern
Updated 08/14/2020 | Published 08/12/2020
Products Featured in This Question
Question:
I need a rim and tire for a spare. The tire is tire is 5.70x8. The rim is 4 bolt pattern with a center hole that I measured as 2.38 inches. Also it requires stud bolts rather than lug nuts. Will a wheel center hole of 2.5 inches be ok. If not any suggestions.
asked by: Chuck W
Expert Reply:
The center pilot hole being larger isn't an issue as the Lug bolts will be used to center your wheel. You can use either the Kenda 5.70-8 Bias Trailer Tire with 8" White Wheel - 4 on 4 - Load Range D # AM30153 rated for up to 1,075 lbs at 100 psi or the Load Range B # AM30080 rated for up to 715 lbs at 50 psi. Whichever more closely matches your current tires would be my recommendation.
Product Page this Question was Asked From
Steel Trailer Wheel - 8" x 3-3/4" Rim - 4 on 4 - White
- Trailer Tires and Wheels
- Wheel Only
- 8 Inch
- 4 on 4 Inch
- Steel Wheels - Powder Coat
- Americana
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Hub/Drum For Lippert Hub Stamped 122093
- Q&A: How To Determine The Correct Replacement Landing Gear Set For Your Trailer
- Q&A: How to Determine Correct Replacement Landing Gear
- Q&A: Why Do Hitch Extenders Reduce Hitch Capacity but Long Ball Mounts Do Not
- Q&A: Will Trailer Wheel with 2-1/2 Inch Pilot Hole Fit in Place of a Wheel with 2-3/4 Inch Pilot Hole
- Q&A: Replacement Bearings, Races, Seal, and Studs for Trailer Hub 008-479-05
- Q&A: Replacement Lid For A MaxxAir MaxxFan Model 4700G
- Article: Glacier Chains