Picking Out Replacement Cylinder for Slide Out of Springdale Clearwater 249BH
Updated 08/10/2020 | Published 08/07/2020
Question:
I need to replace the cylinder on my slide out. Its a 2001 Springdale /clearwater 249bh. I believe the above referenced cylinder matches the measurements on the existing cylinder. just wanna make sure its right.
asked by: Timothy W
0
Expert Reply:
If the hydraulic cylinder you have is an LCI and it matches the dimensions of the # LC342328 below this is the correct replacement:
Port to port length: 41"
Overall tube length: 42-1/16"
Overall length (retracted): 53-1/8"
Stroke: 38"
Bore: 1-1/2"
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Replacement Hydraulic Cylinder for RV Slide-Out - 53" Long
- RV Slide Out Parts
- Hydraulic Parts
- Cylinder
- Lippert Hydraulic Slide-Out Systems
- Lippert
more information >
Continue Researching
- Q&A: Dometic FreshJet 3 Compatibility with CCC2 Thermostat on 2019 Newmar Ventana
- Q&A: Is there a Seal Kit for the Lippert Replacement Hydraulic Cylinder for RV Slide-Out?
- Q&A: Replacement Hydraulic Cylinder for RV Slide-Out
- Q&A: Will Dometic FanTastic Roof Vent Assembly Upgrade Kit Fit Older Fan-Tastic Vent
- Q&A: How To Determine the Correct Replacement Hydraulic Cylinder On an RV Slide-Out
- Q&A: How To Measure For The Correct Replacement Hydraulic Slide Out Cylinder
- Q&A: Correct Replacement Slide Out Cylinder with 39-1/2" Port to Port
- Article: Best Bike Racks for Fat Bikes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)