How To Use Two Square Direct Weld Jacks Together
Updated 08/10/2020 | Published 08/06/2020
Products Featured in This Question
Question:
If I purchased 2 of these jacks what would I need to make them work in tandem similar to landing gear?
asked by: Daryl J
Helpful Expert Reply:
The Square Direct Weld Jack part # TJD-12000SP-F2 can be used in tandem. The only thing you would need to do so would be a cross shaft which would be some sort of bar that attaches the two output shafts to one another. This is assuming you want both jacks to turn at the same time and not have independent operation with two handles.
In regards to the cross shaft, you should be able to cut the Cross Shaft Extension Tube part # BDCS730300 to make it work.
Product Page this Question was Asked From
etrailer Square Sidewind Trailer Jack - Drop Leg - 12-3/8" Lift - 10,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- 5th Wheel Trailer
- Gooseneck Trailer
- Side-Mount Jacks
- Sidewind Jack
- 9001 - 10000 lbs
- Manual Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Q&A: Replacement Parts Available for the RAM Trailer Jack Part # TJD-7000S
- Q&A: Replacement Brake Assemblies and Hub/Drum for Airstream with Nev-R-Lube Hub/Drums
- Q&A: Replacement for AL-KO 5,200 lb Axle
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Replacement Parts for Pro Series 12000 Trailer Jack
- Q&A: What is the Measurement from Bottom of Foot to Outer Tube On Ram Jack when Retracted and Extended?
- Q&A: Looking For Replacement Pins For etrailer Adjustable Ball Mount e66PR
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Double-Eye Trailer Suspension System Review