Correct Replacement Power Control Box for Thomas Payne Seismic Recliner
Updated 08/07/2020 | Published 08/05/2020 >
Question:
The massage function starts when the recliner is powered up and cannot be turned off. The problem appears to be In the control box. Can I replace just the control box and use the existing wire harness? The problem started one night about 6 months after I purchased the seats.
asked by: John J
Expert Reply:
The correct replacement control box for a Thomas Payne Seismic Recliner is the Replacement Power Control Box part # LC36FR. It does not come without the pigtails but if you did not want to use these you could remove them from the unit and use the existing so you don't have to run any additional wires.
Product Page this Question was Asked From
Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas - Qty 1
- Accessories and Parts
- RV Couches and Chairs
- Control Box
- Thomas Payne
more information >
Continue Researching
- Shop: Replacement Power Control Box for Thomas Payne Seismic Recliners and Sofas - Qty 1
- Shop: Replacement Single Zone Controller for Furrion Chill HE Low-Profile RV Air Conditioner Setups - R32
- Q&A: Replacement Dual Track Repair Kits for Lippert RV Schwintek In-Wall Slide-Outs
- Q&A: Replacing Power Control Box for Thomas Payne Seismic Recliners and Sofas
- Q&A: Is The Bracket for RD68RR Plastic?
- Q&A: Thomas Payne Recliner Has Power But Does Not Work
- Q&A: Troubleshooting A Thomas Payne Recliner That Will Not Recline
- Q&A: Replacement Spark Igniter for Furrion 2-in-1 RV Range Oven
- Q&A: Replacement Power Control Box For Thomas Payne Seismic Recliner
- Article: Trailer Wiring Diagrams
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Stability Control for Heavy Duty Vehicles

