Will the Draw-Tite Trailer Hitch # 75671 fit the 2010 Volvo XC60R

Updated 10/08/2012 | Published 10/07/2012

Products Featured in This Question

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(65)

$215.63

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(123)

$207.04

Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs

(3839)

$29.90

Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span

(895)

$15.28

Question:

Im looking for a hitch, for a Volvo XC60R 2010, could you please confirm if this part will fit.

asked by: Christian

Expert Reply:

After some research, I have found that the Draw-Tite Trailer Hitch # 75671 is a good fit for your 2010 Volvo XC60R. In addition, the Curt Class III Receiver Hitch # 13268 is also designed to fit the 2010 Volvo XC60R.

On the Draw-Tite Class III Frame Receiver Hitch, a specific 3/4 inch rise or 2 inch drop ball mount that is 8-1/2 inches long # D-4, and Hitch Pin and Clip, # PC3 must be used. I have included a video on the 3/4 inch rise or 2 inch drop ball mount.

For the Curt Class III Receiver Hitch, there is not a specifically required ball mount and this particular hitch is slightly less expensive than the previous two. However, to install the Curt Class III Receiver Hitch, you must modify the heat shield or trim it for installation. This is not a definite requirement for the previous; the heat shield MAY need to be modified, but it is not mandatory for them.

I have also included a link on how to properly attach a new trailer hitch to your vehicle.