Where are Grease Fittings on Curt A20 Fifth Wheel Hitch
Updated 07/28/2024 | Published 07/24/2020
Products Featured in This Question
Question:
Does anyone have a video of greasing a Curt A 20 hitch. We purchased one in January or February.
asked by: Rex L
0
Expert Reply:
I can help you with info on greasing the A20 hitch but we don't have a video to share at this time. The zerk fittings for the Curt A20 hitch part # C16140 are located on the front of each jaw.The jaws must be in the closed and locked position for the zerks to be accessible. They are kind of hard to see but I attached a picture that points them out.
Curt recommends high pressure grease like the part # L11465. If you need a grease gun we have part # L30200.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt A20 5th Wheel Trailer Hitch - Dual Jaw - 20,000 lbs
- 5th Wheel Hitch
- Fixed 5th Wheel
- Above Bed Rails
- 5000 lbs Vertical Load
- 20000 lbs GTW
- Cushioned Double Pivot
- Standard - Double Jaw
- 13 - 17 Inch Tall
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Installation Video For B&W Turnoverball Gooseneck On 2019-2026 Ram 3500
- Q&A: Would A Sliding Fifth Wheel Hitch Or Rotating Pin Box Be Better For A 2021 Ram 2500 6-1/2' Bed
- Q&A: Does The Gen-Y Nomad 5th Wheel To Gooseneck Adapter Pin Box Improve Ride Quality?
- Q&A: Why Would 7-Way Adapter 20142 Only Work for a Few Hours
- Q&A: Can I Use A Curt A20 With A Reese Sidewinder On A Ram Truck With The Rambox
- Q&A: Grease Fitting Locations for Curt A20 Fifth Wheel Hitch
- Article: Ram Trailer Tow Prep Package
- Q&A: Sidewinder 5th Wheel Pin Box for Lippert 1716
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Set the Right PSI for Your Air Bags
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: The Best 5th Wheel Hitches
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
Earl B.
7/28/2024
One of the zerk fittings on the Curt A20 hitch jaw broke apart as I was trying to disconnect the grease gun. Part of the zerk fitting remains inside the hitch jaw. I don't have an idea about its removal. Need suggestions. I did a search on etrailer for the zerk fitting replacement with no success. Is the A20 jaw a critical lubrication point which wears during trailer towing?