2012 Grand Vitara License Plate Holder with rear mounted spare
Updated 09/19/2012 | Published 09/15/2012
Products Featured in This Question
Question:
Will the left mounted license plate holder interfere with 13001 hitch? The instructions only mentions a small slot cut in the facia.
asked by: David M
Expert Reply:
According to Curt, the fascia mounted license plate holder of your 2012 Grand Vitara will not interfere with the installation of the # C13001 Class III receiver. Fascia trimming is only required on Grand Vitara models that have the spare tire under the vehicle, not on the rear hatch.
If you were planning on using the hitch for towing purposes, you might need the following to complete your towing system:
Ball Mount, part # D-4
Hitch Pin and Clip, # PC3
Trailer Wiring Harness, part # 56002
2 Inch Trailer Ball, part # 19247
1-7/8 Trailer Ball, part # 19260
Locking Hitch Pin, part # e98882
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch and Related Components for 2006 Suzuki Grand Vitara
- Q&A: Correct Trailer Wiring Kit for a 2025 Kia Carnival Hybrid
- Q&A: Recommended Ball Mount for Draw-Tite Trailer Hitch on 2014 Toyota Camry
- Q&A: Troubleshooting Trailer Stop/Turn Circuit Not Active for 2011 Jeep Grand Cherokee
- Q&A: 2024 Ford Explorer Brake Controller and Wiring Recommendation for Trailer Towing
- Q&A: Recommended Trailer Hitch For 2007 Suzuki Grand Vitara
- Q&A: How To Install A Front Mount Trailer Hitch Receiver To Class A Motorhome On Ford F-53 Chassis