Depth of Pin Hole to End of Internal Shank for Hitch Extender # RKY10008
Updated 07/13/2020 | Published 07/09/2020
Question:
Can you let me know the depth from the middle of the hitch pin to the internal tube. I need to make air my bike rack will not bottom out. I need approximately 2 7/8” of depth and have had issues with other extensions and factory receivers.
asked by: Cory E
0
Expert Reply:
From the center of the hitch pin on the female 2 inch hitch portion of the # RKY10008 to the back of the hitch opening measures right at 3-1/2 inches so since you need at least 2-7/8 inches this would fit and work well for you.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
RockyMounts Hitch Extender w/ Hitch Pin and Lock - 2" Hitches - 8" Long
- Hitch Adapters
- Hitch Extender
- Bike Racks
- Cargo Carriers
- Hitch Mounted Accessories
- Trailers
- 8 Inch Extension
- Fits 2 Inch Hitch
- 3500 lbs
- RockyMounts
more information >
Continue Researching
- Q&A: Hitch Extension Options
- Q&A: Does Curt Trailer Wiring Harness Really Fit 2026 Toyota Grand Highlander without Tow Package
- Q&A: What Are The Wires On The Demco Coachlink Transmitter For?
- Q&A: Parts Needed To Attach Yakima Crossbars To A Pace Edwards Ultra Groove Tonneau Cover
- Q&A: Will Torklift Hitch for F-250 Allow 37 inch Spare to Fit
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Q&A: Hitch Extender Recommendation to Fit Yakima OnRamp On RV
- Q&A: Comparing Curt and Draw-Tite Hitch Receiver Locations for a Bike Rack on a 2024 Ford Bronco
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)
- Article: Which Hitches are Made in the USA
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Hitch Adapters and Extenders
- Article: Where to Position the Trailer Axle?
- Article: Trailer Wiring Diagrams