Which Class III Trailer Hitch Receiver Provides Most Ground Clearance for 2007 Toyota Sienna LE  

The etrailer Trailer Hitch Receiver #e98837 will fit all models of Toyota Sienna from model years 2004 through 2020. I have added links below to a number of video installs of different model year Siennas for you to check out as well of the etrailer…

When the Draw Tite trailer hitch part #75237 is installed on your 2015 Toyota Sienna it will have relatively low ground clearance since the rear of the vehicle hangs so low. There really isn't a way around that but to tow a trailer level…

The Tekonsha T-One #118304 and Curt T-Connector #C55580 Vehicle Wiring Harnesses are very similar. These are both custom fit wiring harnesses that include a tail light converter, which is required for your 2007 Toyota Sienna because the brake and…

To tow a trailer with your 2007 Toyota Sienna, the best hitch is going to be the Class III Draw-Tite #75237 over the Class III option from Curt because the Draw-Tite is rated for a higher capacity and is also the more economical choice. This hitch…

I am sorry to hear you are having problems towing your boat with your 2010 Toyota Sienna. There are a couple of solutions that may work for you. The best and safest way to eliminate the sag at the rear of your vehicle, that occurs when the boat…

We currently have two different 2" trailer hitch receivers for your 2010 Toyota Sienna XLE which are the Curt Trailer Hitch Receiver part #C13105 and the Draw-Tite Max-Frame Trailer Hitch Receiver part #75237. When we tested the Curt hitch on a…

For your 2011 Toyota Sienna, I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #75237. Using this trailer hitch receiver, you can use the etrailer Motorcycle Carrier w/ Ramp for 2" Hitch - 76"…

As far as installation and strength are concerned, the two hitches are actually very similar. Both install in the same location and mounting holes on the vehicle, and both are rated to tow up to 3500lbs. Both hitches will also have a similar ground…

We sure do. I had our warehouse measure the Draw-Tite Trailer Hitch #75237 you were looking at for your 2010 Toyota Sienna and it measures 53-3/8" measured center to center of the mounting holes, 1-5/8" between the furthest rearward and…

I do have a trailer hitch for your 2010 Toyota Sienna but the one for a Toyota Venza will not fit as the vehicle's have a different rear subframe so the holes will not line up unfortunately. For your Toyota Sienna, I recommend using the Draw-Tite…

Having all-wheel drive will not affect the fit or the installation of the etrailer.com Trailer Hitch Receiver #e98837 on a 2016 Toyota Sienna. The installation will be the same for all models of '16 Sienna and the same is true for similar hitches…

All of the trailer hitches for your 2006 Toyota Sienna are going to sit in the same area. You'll get slightly better ground clearance from a hitch with an 1-1/4" receiver and when the installed the Curt #C12065 and Draw-Tite #36513 Class II…