What Are the Break In Procedures for the etrailer 4500-Watt Generator
Updated 06/29/2020 | Published 06/26/2020 >
Question:
Whats the correct procedure to break in a new generator?
asked by: Ken M
Expert Reply:
We consider the first 5 hours of run time on the etrailer 4500-Watt # 333-0005 to be the break-in period for the unit. During the break in period stay at or below 50 percent of the running watt rating and vary the load occasionally to allow stator windings to heat and cool. Adjusting the load will also cause engine speed to vary and help seat piston rings
The only thing we do recommend is that the first oil change should happen after 25 hours of use, but after that you will only need to change it every 100 hours.
Product Page this Question was Asked From
4,500-Watt Portable RV Generator - 3,600 Running Watts - Propane or Gas - Electric Start
- Generators
- No Inverter
- Gas
- Gas and Propane
- Propane
- 3001 - 4000 Watts
- Portable Generator
- 120V Output
- Carbureted
- Electric Start
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Availability of a Replacement Control Board For a Dometic 991762494 Dual Zone
- Q&A: Does Champion 4,500-Watt Dual Fuel Portable Inverter Generator Operate at High Altitude
- Q&A: TorkLift SuperHitch and Tie-Downs For a 2024 Ford F-350 Super Duty
- Q&A: Would Ryobi RY903600 Work To Power A Travel Trailer
- Q&A: Why Won't My etrailer Generator Start on LP Gas
- Q&A: Furrion Chill Cube Startup Amp Draw and Generator Compatibility
- Q&A: Correct Gen-Y Gooseneck Pin Box for a Brinkley 5th Wheel Trailer
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Replace or Install an RV Roof Vent
- Article: Calculating Portable Generator Power Needs
- Article: How Much Solar Power Do I Need For My RV?

