Tube Mount Diameter and Pin Size for Bulldog Swivel Trailer Jack # BD190705
Updated 08/22/2012 | Published 08/20/2012
Question:
BD190705 trailer jack need to know the inside diameter off the sleeve that is welded on to the trailer the one on my trailer is 2.5 inches inside dia with a pin dia of 7/8 of inch
asked by: Glen
0
Expert Reply:
I spoke with my contact at Bulldog and the inner diameter of the tube that gets welded to the trailer is 2-1/2 inches so the jack would fit the tube that is on your trailer. However, the pin diameter is 5/8 inches and not 7/8 inches. The 5/8 inch pin diameter is the common size and I was unable to find one with a 7/8 inch diameter pin.
expert reply by:
Michael H
0
Continue Researching
- Search Results: bulldog square jack
- Search Results: jack
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Topwind - 28-3/4" Lift - 7,000 lbs
- Q&A: Battery Heater for Group 31 Battery
- Q&A: What are the Mounting Hole Dimensions for the Bulldog A-Frame Trailer Jack # BD155032
- Q&A: Pipe Mount Swivel Jack Rated for 3K with 15 Inch Lift and Retracted Height between 12 and 14 Inches
- Q&A: Overall Retracted Height of Bulldog Trailer Jack Part # BD171401
- Article: Can You Flat Tow a Jeep Compass?
- Q&A: How to Lubricate the Bulldog Top Wind Round A-Frame Jack # BD155032
- Article: Trailer Maintenance Schedule
- Q&A: Middle Mounting Bracket to Top of Handle Distance for Bulldog Square Swivel Jack w/ Round Pipe Mount
- Q&A: Recommendation for Pipe-Mount Swivel Trailer Jack that has a Grease Fitting
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Trailer Hitch Drop
- Article: Testing Trailer Brake Magnets for Proper Function