Can the Valterra Rotating Sewer Adapter Be Temporarily Installed
Updated 06/11/2020 | Published 06/09/2020
Products Featured in This Question
Question:
Id like to use the Valterra Rotating Adapter for Rigid RV Sewer Pipe - 3 Hub to 3 Bayonet - Black Plastic to install a rigid sewer pipe, but I dont want to glue the end so that I can get it a part at the end of the season. Is there a removable coupler that will install over the hub?
asked by: Michael A
Expert Reply:
The Valterra Rotating Adapter for Rigid RV Sewer Pipe part # T1028 is designed to be welded to the end of a 3" ABS sewer pipe. However, if you don't want to permanently attach the sewer pipe to the hub fitting you could most likely just use a gasket maker like part # LT37467 to stop any leaks.
Product Page this Question was Asked From
Valterra Rotating Adapter for Rigid RV Sewer Pipe - 3" Hub to 3" Bayonet - Black Plastic
- RV Sewer Hose Fittings
- Sewer Adapters
- Sewer Pipe Adapters
- Bayonet
- Hub
- Sewer Pipe to Waste Valve
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Q&A: Are Furrion Chill The Cube AC Units Worth the Hype
- Q&A: Should Air Lift WirelessONE Compressor Kick On When Truck Is Sitting With Everything Off?
- Q&A: What Comes With Furrion Chill Cube FR99TD
- Q&A: Adding a Blade Valve to the end of my Tanks Dump Plumbing
- Q&A: Difference Between Furrion Chill Cube FR39TD and FR49TD
- Q&A: Is There a Furrion Chill Cube Setup that Works as Both a Dump Setup and Through Ducts
- Q&A: Replacement Table Leg Recommendation for a Lagun Table in a Leisure Travel Van
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Which Hitches are Made in the USA
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: The Ultimate RV Camping Checklist for Your First Year RVing