How to Determine What Factory a 2011 Hyundai Elantra was Built In
Updated 08/13/2012 | Published 08/10/2012
Question:
How do I know if my Elantra may not align with the pre-drilled holes in the hitch. I have a 2011 is there a way to see which plants have the correctly drilled holes?
asked by: Jennifer N
Expert Reply:
You can contact the dealer and have them look up the VIN and they should be able to tell you. There is also a sticker on the driver side door jamb that should show where the vehicle was made.
The issue is that on Korean built models there is a hole that is not present on the frame that would have to be drilled using the hitch as a template. All the other attachment points are correct. This is an issue on the sedan models but we have not heard about issues on the hatchbacks.
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Looking For Replacement For 013-143-03 Equalizer And Dexter Shocks On 2018 Cruiser 2916 RV
- Q&A: Where Does a Stabilizing Strap Attach for a Cargo Carrier and CURT Trailer Hitch, 2009 Toyota Prius
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How To Deal With Muffler Rattling Against Trailer Hitch On 2012 Hyundai Elantra
- Q&A: Can a 2007 Hyundai Accent Pull a Trailer and What Parts Are Needed
- Q&A: Draw-Tite Receiver Location Relative to Rear Bumper of 2009 Hyundai Elantra
- Q&A: Towing Small Jon Boat with 2013 Hyundai Elantra GT