Diameter of Replacement Stand-Off Brace for Surco Universal Exterior RV Ladders
Updated 05/14/2020 | Published 05/13/2020
Products Featured in This Question
Question:
I have to attach a one inch electrical conduit to the side of the ladder pipe using a U-Bolt. The U-Bolt can be 1-1/8 or 1-3/8 wide. Do you know if the outside diameter of the ladder pipe is exactly 1 inch or a little bigger. Im 100 miles from my RV right now, so I cant measure. Thanks
asked by: John G
Expert Reply:
The diameter of the Replacement Stand-Off Brace for Surco Universal Exterior RV Ladders SP501L and SP502L # SPN-416 is 1 inch. I do have to say that there can be some ever-so-slight variances with all products when it comes to dimensions, but it will be as close to 1 inch as can be.
The Replacement Stand-Off Brace # SPN-416 is a replacement for the Surco Universal Exterior RV Ladder - 84-1/2" Long # SP502L and Surco Universal Exterior RV Ladder with Center Hinges for Contoured Rear Wall - 97" Long # SP501L.
Product Page this Question was Asked From
Replacement Standoff for Surco Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- Support Peg
- Surco Products
more information >
Continue Researching
- Q&A: Availability of a Replacement Control Board For a Dometic 991762494 Dual Zone
- Q&A: What is Length of Stromberg Carlson Stand Off SCS44SR
- Article: How to Drain an RV Water Heater
- Q&A: If the Stromberg Carlson RV Ladder Was Not Installed Into Studs Is It Safe To Use?
- Q&A: Ladder Standoff Replacement with Square Base
- Q&A: What Does Roll Pin Look Like on Replacement Ladder Rung
- Q&A: Replacement GE Air Conditioner for a ARC15AACBL2
- Q&A: Replacement Water Heater for Atwood GC10A-3E
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Can You Flat Tow a Ford Escape?