Handle Needed For Sidewind etrailer Square Direct Weld 10K Jack
Published 04/09/2020
Products Featured in This Question
Question:
I need part number ?
asked by: Dale P
0
Expert Reply:
The handle that you need for the Square Direct Weld Jack - Drop Leg w/ Spring Return part # TJD-12000SP-R2NH is part # TJD-12000-HD. This handle replaces the handle on all of the TJD-12000 Series square jacks. It comes with the bolt and hardware needed to install.
expert reply by:
Heather A
0
Product Page this Question was Asked From
etrailer Square Jack - Side Pin Drop Leg - Spring Return - 10K Lift - 25-3/4" Travel
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- 5th Wheel Trailer
- Gooseneck Trailer
- Side-Mount Jacks
- 9001 - 10000 lbs
- Manual Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Can etrailer Square Direct Weld Jack Replace Buyers Products 0091410
- Q&A: Recommended Hitch for a 2025 Mercedes AMG GLE 53
- Q&A: Replacement Landing Gear Jack for Ram Follow 12k Jack on Trailer
- Q&A: How To Re-Assemble The RAM TJD-12000SP Trailer Jack
- Q&A: How Long Does It Take To Install Air Force One Supplemental Braking System
- Q&A: Is There a Powered Drive Kit for the Ram Square 2-Speed Jack
- Article: Trailer Wiring Diagrams
- Article: Slipper Spring Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Jacks
- Article: Best Landing Gear