Can Side Marker Light on Trailer Be Wired as a Blinker Light
Published 03/24/2020
Products Featured in This Question
Question:
Can a side marker light be wired as a side marker signal light, to be mounted beside the regular side marker lights
asked by: William B
0
Expert Reply:
Yes, you can use a taillight converter like part # 118158 to separate out a turn signal circuit so that you could power a side marker light as a blinker.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Trailer Clearance or Side Marker Light - Submersible - 6 Diodes - Amber Lens - 24V
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 4L x 1W Inch
- Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Is There a Cover for a Single 30 Lb Propane Tank
- Q&A: Replacement Trailer Clearance LED Lights with 2 3/4 Mounting Hole Spacing
- Article: Trailer Wiring Diagrams
- Q&A: Recommended On/Off Push Button Switch That Always Stays On Until Pushed Again
- Q&A: Availability of Red 328 LED Bullet Clearance Side Marker
- Q&A: Troubleshooting EOH Brakes With Hydrastar Actuator Not Working With 2024 Ford F-450
- Q&A: Replacement Slam Latch for Jayco Seneca
- Q&A: Ford Integrated Brake Controller Not Working Well with Trailer with Electric/Hydraulic Setup
- Article: Upcoming 2025 Sierra Must-Have Accessories Guide
- Article: Safety-Chain Attachments for Gooseneck Hitches on 5th Wheel Rails
- Article: In the Market for a Teardrop Camper? You'll Want to Pay a Visit to Hyk Outdoors
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers