Recommended Draw Bar for Curt Class I Hitch on a 2019 Mitsubishi Mirage G4

Updated 03/24/2020 | Published 03/23/2020

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(14)

$219.35

ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit

(522)

$192.72

No-Drill Mount for Electrical Mounting Bracket - Short

(1180)

$21.57

Mounting Bracket 4-Pole Flat

(6113)

$10.04

1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs

(334)

$33.63

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(334)

$36.80

Curt Trailer Hitch Receiver Lock - 1-1/4" and 2" Hitches - Stainless Steel

(281)

$39.94

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs

(2273)

$49.70

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2932)

$2.69

Question:

i need a draw bar four this whut would u say

asked by: Keith Y

Expert Reply:

The draw bar that is recommended to be used with the Curt Trailer Hitch Receiver # C11449 on your 2019 Mitsubishi Mirage G4 is the Curt # C45521 which has a 2-5/8" Rise/3-1/4" Drop.

To secure this to the hitch receiver you need a pin & clip # F-4 or locking hitch pin # C23517 and then you also need a hitch ball like the 1-7/8" # A-80 or 2" A-82.

A complete towing setup also requires wiring to activate the trailers lights. For your application I recommend the Tekonsha ZCI # 119250KIT because it clamps onto your OEM wiring instead of splicing and then it pulls power directly from your vehicle battery and includes a circuit-protected module so you don't have to worry about anything happening to your OEM wiring even if something malfunctions on your trailer side of things.

You can either leave the 4-Way in your rear hatch area or you can keep it next to your hitch receiver using the brackets # 18144 and # 18140.

Attached are some videos for you to check out.